System Global - Fortinet Version 3.0 Administration Manual

system global

system global
Use this command to configure global settings that affect various FortiBridge systems and
configurations.
Command syntax pattern
config system global
end
config system global
end
get system global
show system global
Keywords and variables
admintimeout
<minutes_integer>
dst {disable | enable}
heartbeat {disable |
enable }
hostname <name_str>
interface-speed {100full
| 100half | 10full |
10half | auto }
ntpserver {<name_str> |
<address_ipv4>}
ntpsync {disable |
enable}
66
set <keyword> <variable>
unset <keyword>
Description
Set the administrator idle timeout to control the
amount of inactive time before the administrator must
log in again. The maximum admintimeout is 480
minutes (8 hours). To improve security keep the idle
timeout at the default value.
Enable or disable daylight saving time.
If you enable daylight saving time, the FortiBridge unit
adjusts the system time when the time zone changes
to daylight saving time and back to standard time.
For future use.
Type a name for this FortiBridge unit.
This command is only available for the FBG-1000.
Set the network interface speed or allow each
interface to auto-sense the correct speed. Set to
auto, each FortiBridge network interface will
autosense the correct speed and adjust accordingly. If
the interface-speed command is used to specify a
speed, all FortiBridge interfaces are locked to the
selected speed.
Although the FortiBridge supports 10/100/1000mbps
speeds when set to auto, 1000half and 1000full are
not available for manual selection.
Some early units will return an Not supported by this
hardware error when this command is invoked. This is
normal as hardware support for interface-speed
was only added in later units.
Enter the domain name or IP address of a Network
Time Protocol (NTP) server.
Enable or disable automatically updating the system
date and time by connecting to a Network Time
Protocol (NTP) server. For more information about
NTP and to find the IP address of an NTP server that
you can use, see http://www.ntp.org.
config CLI commands
Default
5
disable
disable
FortiBridge model
name.
auto
132.246.168.148
disable
FortiBridge Version 3.0 Administration Guide
09-30000-0163-20061109