Dismantling And Renewing Parts - GGP ITALY SPA 122 Owner's Manual

EN 46
6.4 DISMANTLING AND REPLACEMENT
6.4.1 R
EPLACING WHEELS
Stop the machine on a flat surface and put a block
under a load-bearing part of the frame on the side
that the wheel is to be changed.
The wheels are held by a snap ring (1) which can be
eased off with a screwdriver.
The rear wheels are directly coupled to the differen-
tial axle shaft and fastened by a key that forms part
of the wheel's hub.
NOTE
they are of the same diameter, and check that cutting deck is horizontal to pre-
vent an uneven cut.
IMPORTANT
the axle and carefully re-fit the snap ring (1) and washer (2).
6.4.2 R
EPLACING AND REPAIRING TYRES
The tyres are of the «Tubeless» type and therefore all puncture repairs will have
to be carried out by a tyre-repair expert in accordance with the methods for this
kind of tyre.
6.4.3 R
EPLACING BULBS
The bulbs (18W) have a bayonet fitting
and are installed in the bulb holder which
can be taken out by turning it anti-clock-
wise, using pliers.
Should you substitute one or both rear wheels, ensure that
Before re-fitting a wheel, smear some waterproof grease on
MAINTENANCE
1
2