GGP ITALY SPA 122 Owner's Manual page 11

EN 10 UNPACKING AND ASSEMBLY
truding shaft (2) with the spokes directed towards the seat.
Line up the hole in the steering wheel hub with the hole in the shaft and insert
the pin supplied (3) using a hammer, ensuring that the end comes completely
through to the opposite side.
NOTE
To avoid damaging the steering wheel, use a punch or a
screw-driver of the same size as the pin when hammering it in the last part
3.3 FITTING THE SEAT
4
Raise the adjustment lever (3) and fit the
seat (1) in the slide (2), introducing it from
the steering wheel's side, till the seat
engages in one of the 6 positions.
2 1 3
At this point the seat is engaged and can-
not be completely removed unless the
lever (4) is pressed, freeing it from its
retainer
3.4 ASSEMBLY AND CONNECTING
THE BATTERY
3
Position the battery (1) in its compart-
1
ment under the seat.
Connect the red cable (2) to the posi-
tive terminal (+) and the black cable (3)
to the negative terminal (–) using the
supplied screws and following the illus-
trated sequence.
Fit the spring (4) to hold the battery in
4
2
place and make sure all the wires are