Table of Contents
Advertisement
EN 50
great care when using for the first few times as engagement may be sudden
until the belt is sufficiently run in.
6.3.6 A
DJUSTMENT OF THE SPRING OF THE PAWL FOR HOOKING THE GRASS
If the grass-catcher tends to jump about and to
open up when going over rough ground, or if it has
difficulty in hooking back on after being emptied,
the tension of the spring will need to be adjust-
ed(1).
Change the hooking point by using one of the
holes (2) until the required result is achieved.
6.4 DISMANTLING AND REPLACEMENT
6.4.1 R
EPLACING WHEELS
Stop the machine on a flat surface and put a block under a load-bearing part of
the frame on the side that the wheel is to be changed.
The wheels are held by a snap ring (1) which can be eased off with a screwdriver.
The rear wheels are directly coupled to the differential axle shaft and fastened by
a key that forms part of the wheel's hub.
NOTE
both rear wheels, ensure that they are of the
same diameter, and check that cutting deck is
horizontal to prevent an uneven cut.
IMPORTANT
some waterproof grease on the axle and carefully
re-fit the snap ring (1) and washer (2).
Should you substitute one or
Before re-fitting a wheel, smear
MAINTENANCE
-
CATCHER
1
2
1
2
Hide quick links:
Advertisement
Table of Contents
