The Fortigate-5005-Dist Security System; Basic Fortigate Security System Configuration - Fortinet FortiGate-5000 Introduction Manual

The FortiGate-5005-DIST security system

The FortiGate-5005-DIST security
system

Basic FortiGate security system configuration

FortiGate-5000 Series Introduction
01-30000-83466-20090108
The FortiGate-5005-DIST security system is very similar to a single FortiGate unit,
but with much higher capacity and with support for failover protection and
scalability. The FortiGate-5005-DIST security system consists of a FortiGate-5050
or FortiGate-5140 chassis with one or two Input/Output or I/O boards
(FortiController-5208 boards) and one or more worker boards (FortiGate-5005FA2
boards running in DIST mode). The I/O boards provide 10-gigabit and 1-gigabit
network connections and distribute traffic to the worker boards. The worker
boards provide FortiGate security system functions including firewall, VPN, IPS,
antivirus, antispam, and so on.
The following topics are included in this section:
• Basic FortiGate security system configuration
• FortiController-5208 I/O boards
• FortiGate-5005FA2 worker boards
• FortiGate-5005-DIST security system chassis
• FortiGate-5005-DIST interface names
A basic FortiGate security system consists of a single FortiController-5208 board
and four FortiGate-5005 boards installed in a FortiGate-5050 or FortiGate-5140
chassis (see Figure 29 on page
mode between the Internet and a private network. In this configuration, the
FortiGate-5005-DIST security system can provide FortiGate services to 10 gigabit
traffic passing between the private network and the Internet.
Basic FortiGate security system configuration
68). This system can be installed in NAT/Route
67