Leds - Fortinet FortiGate-5000 Introduction Manual

FortiSwitch-5003A system

LEDs

FortiGate-5000 Series Introduction
01-30000-83466-20090108
Table 16 lists and describes the FortiSwitch-5003A front panel LEDs.
Table 16: FortiSwitch-5003A front panel LEDs and switches
LED State
OOS (Out of Service) Off
Red
ACT (Active) Green
Yellow
Off
HTY (Healthy) Green
Off
FLT (Fault) Off
Yellow
RST (Reset switch) Press and hold Reset for three seconds to restart the
FortiSwitch-5003A board.
Solid
Green
Base Network Activity
LEDs
Blinking
Green
Off
Solid
Green
Fabric Network
Activity LEDs
Blinking
Green
Off
MGMT, B1, Link/Act Solid
(Left Green
B2
LED)
(Management
Blinking
and base Green
1-gigabit
Off
LEDs)
Speed Green
(Right
Amber
LED)
Off
Description
Normal operation.
Out of service. The LED turns on if the
FortiSwitch-5003A board fails. The LED may also
flash briefly when the board is powering on.
The FortiSwitch-5003A board is powered on and
operating normally.
Caution status. Caution status is indicated by the
fault condition of the HTY and FLT LEDs.
The board is not connected to power.
The FortiSwitch-5003A board is powered on and
operating normally.
The board health system has detected a fault.
Normal operation.
Cannot establish a link to a configured interface or
another connection problem external to the
FortiSwitch-5003A board. This LED may indicate
issues that do not affect normal operation.
Indicates this interface is connected to the 1-gigabit
base channel interface of a FortiGate-5000 board.
Table 17 on page 56 lists the base network activity
LEDs and the interface that each represents.
Indicates 1-gigabit network traffic on this interface.
No link.
Indicates this interface is connected to the
10/1-gigabit fabric channel interface of a
FortiGate-5000 board. Table 19 on page 58
fabric network activity LEDs and the interface that
each represents.
Indicates 10/1-gigabit network traffic on this interface.
Table 19 on page 58 lists the fabric network activity
LEDs and the interface that each represents.
No link.
Indicates this interface is connected with the correct
cable and the attached network device has power.
Indicates network traffic on this interface.
No Link
Connection at 1 Gbps.
Connection at 100 Mbps.
Connection at 10 Mbps.
Front panel LEDs and connectors
lists the
55