Table of Contents
Advertisement
10
GE N E R AL IN TERFACES
Configuration Switches
The configuration switches are used to set the flash mode for each output separately.
The selections allow the outputs to be controlled by a remote input, a telephone call, or a
combination of remote inputs, say, for example to control 2 lights such as "Rehearsal" and
"Live", using the Settings in Figure 10-4 to 10-6.
Latching and Momentary Mode
The configuration switches are also used to select the operating mode, either latching or
momentary, for each output. The operating mode is set when power is applied to the unit
and the configuration switches are set to either Setting 15 or 16. The Output will flash once
to indicate latching mode has been selected or twice to indicate momentary mode has
been selected. The configuration switches can then be returned to the required Setting.
In Latching Mode (Setting 15 selected on power up), the Output is On/Flashing only while
the selected Remote Inputs remain asserted. In Momentary Mode (Setting 16 selected on
power up), each separate assertion of the selected Remote Inputs changes the state of the
Output. For example, using setting 4, the first assertion of Remote 1 switches Output 1 on.
The second assertion of Remote 1 switches Output 1 off. The operating mode has no effect
when using Settings No1-3.
The available settings for output 1, configured using switches Sw1 to Sw4, are
detailed below:
Setting
No
1
2
3
4
5
6
7
8
9
10
11
12
60
Sw1
Sw2
Sw3
Sw4 Description
Off
Off
Off
On
Off
Off
Off
On
Off
On
On
Off
Off
Off
On
On
Off
On
Off
On
On
On
On
On
Off
Off
Off
On
Off
Off
Off
On
Off
On
On
Off
Flash Output 1 when telephone rings.
Off
Output 1 On when telephone is off-hook
Off
Output 1 On when telephone is off-hook
Off
Flash Output 1 when telephone rings
Off
Output 1 On when Remote 1 asserted
Off
Output 1 On when Remote 2 asserted
Off
Output 1 On when Remote 3 asserted
Off
Flash Output 1 when Remote 1 asserted
Off
Flash Output 1 when Remote 2 asserted
On
Flash Output 1 when Remote 3 asserted
On
Output 1 On when Remote 1 or Remote 2 asserted
Output 1 On when Remote 1 asserted and Remote
On
2 not asserted
Output 1 On when Remote 1 not asserted and
On
Remote 2 asserted
Redbox User Handbook No 3
Advertisement
Table of Contents
