2
MIXER & SOURCE SELEC TORS
buttons will display the current operating mode (as shown below). To change the mode,
simply press the input 10 and the buttons will indicate the newly selected mode. Once the
required operating mode has been set the unit will restart within five seconds from the last
button press.
INPUT 1 button on
INPUT 2 button on
INPUT 3 button on
Rear Panel Connections and Operation
Fig 2-4: RB-DSS10 Rear Panel.
RB-DSS10 Inputs
AES/EBU Inputs
The 8 digital input XLR 3 pin sockets have an impedance of 110Ω. They have the following
connections:
Pin 1: Screen
Pin 2: Phase
Pin 3: Non-phase
The signals on this connector should meet the IEC 60968 specification
RB-DSS10 Outputs
AES/EBU Outputs
The digital output XLR 3 pin socket has an impedance of 110Ω. It has the following
connections:
Pin 1: Screen
Pin 2: Phase
Pin 3: Non-phase
The signals on these connectors will comply with the IEC 60968 specification
14
AES/EBU
Inputs
=
Alternate mode
=
Latched mode
=
Protected Alternate mode
Remote
AES/EBU
Start I/O
Output
Digital Audio
Inputs & S/PDIF
Output
Remote Select/
Switch Inputs
Status
Outputs
Redbox User Handbook No 3