Socket CF RFID Reader Card User Manual page 42

4. RFID Demo will report any data saved to the RFID tag, as well as the type of
tag and number of bytes per block. The bottom of the screen will report the
read status and tag ID.
5. To write data to the tag, enter text into the bottom field. The type and amount
of text that can be written varies depending on your tag type. After entering
text, hold the Pocket PC in the correct reading/writing position and tap Write
Tag.
Note:
• The number of characters in the Write Tag field must match the number of
bytes per block multiplied by the number of blocks, or an error will occur.
• See Appendix B to find out the type and amount of text that can be written
to your tag.
• The most common cause of write failures is either an incorrect "start block"
or number of blocks.
42