Setting Up The Phone; Cleaning; Connecting The Phone - Snom 200 Administrator's Manual

included in the package. Other power supplies may cause damage to the
phone, affect the behavior or induce noise.
1

Setting up the Phone

that enable the rubber pads to ensure a secure grip. Do not place the
snom 200 on carpets or other materials that contain fibers that could
block the air vents and cause overheating.

Cleaning

cleaning liquids as they might damage the surface or internal electronics
of the phone.

Connecting the phone

then to the jack on the left-hand side of the phone.
which is named "NET" and is the nearest to the middle of the phone, and
plug the other end into the network side to establish a data link. The
second RJ45 connector at the edge of the phone named "PC" or "UP0" is
for daisy-chaining further Ethernet devices without the need for a second
Ethernet connection line.
the data line and hook up the casing into the mains.
jacks on the rear side of the snom 200. The connector named "in" is for
the microphone.
10 • Installation
[ 2 0 0 A
S N O M D M I N I S T R A T O R
If you want to use an external power supply, use the one that is
The snom 200 should only be placed on even, horizontal surfaces
To clean the snom 200 use an anti-static cloth. Please avoid
First connect one end of the handset cable to the handset and
Next plug the Ethernet (network) cable into the RJ45 connector,
Iinsert the plug of the power supply into the connector next to
If you want to use a headset, it can be connected to the audio
M V 3 . 0 0 ]
A N U A L