Executing Switches; Adjusting Volume - AMX Precis DSP Instruction Manual

Fine-Tuning with APGraphic EQ

Executing Switches

Before fine-tuning the system for its final location, route a few switches to check that the system is
working properly and to determine what adjustments are needed.
This section provides basic information for executing switches using the CrossBar. For complete control
information using APGraphic EG, see page 28.
To execute switches with the APGraphic EQ CrossBar:
1.
Open APGraphic EQ (see page 18).
2.
From the Options menu, select Show > CrossBar View.
3.
Click a crosspoint to execute a switch.
The crosspoint changes to an active state and the switch is routed. (Click an active crosspoint to
disconnect a switch.)

Adjusting Volume

This section explains how to adjust volume using the APGraphic EQ main interface.
To adjust volume for an output:
1.
Using the CrossBar, route an input to the output needing adjustment.
2.
From the main interface, select the output from the Output Device list and adjust the Volume slider.
Output Device list
22
Tip: Place the cursor over a crosspoint
to display the input/output numbers for
that crosspoint.
Volume slider
Mute / Unmute button
Outputs
Selected (active) crosspoint
Inputs
Precis DSP Instruction Manual