Adjusting Tone - AMX Precis DSP Instruction Manual

Adjusting Tone

Tone is normally adjusted along with balance and volume as part of system setup and fine-tuning but can
be adjusted any time during operation.
Note: The button immediately left of the Reset button is used to toggle between the Tone and EQ
sliders. When the EQ sliders are visible, the button says Tone; when the Tone sliders are visible,
the button says EQ.
To adjust tone for an output:
1.
Using the CrossBar, route an input to the output needing adjustment.
2. From the main interface, click the Tone button.
The Tone sliders appear.
3.
Select the output from the Output Device list.
4.
Adjust the sliders for bass and treble until the desired sound is achieved.
Tip: The Tone bands for an output can be set to 0 (flat response) by clicking the Reset button.
5.
Repeat Steps 1 through 4 for additional outputs as required.
6. Click the EQ button to return to the main interface.
Precis DSP Instruction Manual
Fine-Tuning with APGraphic EQ
Bass and Treble sliders
Click EQ button to return to equalization bands
25