Table of Contents
Advertisement
Figure 202
AXT-CP lithium batteries
Caution
There is a danger of explo-sion
if you replace the battery
incorrectly. Replace the battery
with the same or equivalent type
recommended by the
manufacturer. Dispose of used
battery according to the
manufacturer' s instruc-tions.
Never recharge, disassemble,
or heat the battery above 212 ° F
(100 ° C). Never solder directly
to the battery or expose the
contents of the battery to water.
128
Replacing the Lithium Batteries
Flip the touch panel face down onto a soft cloth, and remove the seven Phillips-
3.
head screws from the bottom panel. Then, gently remove the panel.
Remove the Phillips-head screw located in the center of the circuit card.
4.
Gently tilt the circuit card down towards the connector side and pull backwards
5.
until you clear the connector housing. Then, slowly rotate the circuit card
backwards until you can lay it down flat with the batteries exposed. Figure 202
shows the batteries on the AXT-CP circuit card.
Carefully slide one battery out of its socket, and insert the new battery.
6.
Rotate the circuit card back to the original position and place it in the touch
7.
panel housing. Do not insert the mounting screw.
Plug the two-pin power or AXlink connector back into the touch panel for
8.
approximately 1 minute. Then, remove connector from the panel again.
Gently tilt the circuit card down towards the connector side and pull backwards
9.
until you clear the connector housing. Then, slowly rotate the circuit card
backwards until you can lay it down flat with the batteries exposed.
Carefully slide the other battery out of its socket, and insert the new battery.
10.
Lithium batteries
Color Passive-Matrix LCD Touch Panels
Advertisement
Table of Contents
