Figure 9
AXU-CP or AXU-CP/PB, and
BB-TP2 cutout dimensions for
plasterboard
Color Passive-Matrix LCD Touch Panels
Cut the surface according to the cutout dimensions shown in Figure 9.
1.
Insert a flat-blade screwdriver into the release slot on the touch panel' s bezel
2.
and remove the engraved overlay.
Lay the touch panel face down onto a soft cloth and remove the four screws
3.
from the low-profile back box. Remove the back box and discard.
Place the BB-TP2 into the cutout and mark the threaded insert positions as
4.
shown in Figure 9.
Remove the BB-TP2 and drill four #6-32 insert holes. Then, place a threaded
5.
insert into each hole.
Installing the Touch Panel
11