Figure 7
AXU-CP or AXU-CP/PB, and
BB-TP2 cutout dimensions for
a solid surface
Note
The BB-TP2 can also be
mounted to wood or metal
studs using the pre-drilled stud
mounting holes.
Color Passive-Matrix LCD Touch Panels
Insert a flat-blade screwdriver into the release slot on the touch panel' s bezel
2.
and remove the engraved overlay.
Lay the touch panel facedown onto a soft cloth and remove the four screws from
3.
the low-profile back box. Remove the back box and discard.
Place the BB-TP2 into the cutout and mark the threaded insert positions as
4.
shown in Figure 7.
Remove the BB-TP2 and drill eight holes as shown in Figure 7. Then, place #6-32
5.
threaded inserts into the four holes marked ' B' in the cutout dimensions
illustration.
Disconnect the AXlink connector from the AMX Control System that supplies
6.
power and data to the touch panel. Then, disconnect the optional RS-232
connector from the external RS-232 device connected to the touch panel.
Remove one or more knockouts to accommodate the wiring as required.
7.
Installing the Touch Panel
9