Elation DMX OPERATOR PRO User Manual page 15

7.3.2 Record a Moving Light Chase (Cont.)
(4) Next, set your desired hold and fade time for your first Chase step by using the
"SPEED" fader for your HOLD time and the "FADE" fader for your FADE time. The
hold and fade time range is five tenths of a second to ten minutes. Therefore, the
maximum times that can be set to hold or fade a selected scene step is 10 minutes
and the minimum time is .5 second. Note: When adjusting the speed fader, "S"
represents "Speed" followed by the set hold time- .05 to 59.00S (Seconds), after 59
seconds, the LCD will display "1M00S", "M" represents minutes and can be adjusted
up to 10M00S (10 minutes and 0 seconds). "F" represents Fade time.
(5) Once your scene is selected and your speed and fade times have been set, press the
"RECORD" button, all of the LED's will flash one (1) time and your Chase step will
advance one (1) time as well. The LCD will display the following:
•
"TL" represents total Chase steps and "STEP" represents current Chase step.
This becomes important when wanting to edit your Chase later (See Editing
Moving Light Chases in section 7.5 on page 18).
(6) Repeat steps 3-5 to continue recording additional steps into your Chase. Each time
you record a new scene into your Chase, the Chase step will advance by one (1). You
can store up to 99 steps maximum per Chase.
(7) Once you've completed recording your Chase, press the "ESC" button two (2) times
to exit record mode.
EDIT CHASE1/TL01
ADD ESC STEP01
DMX OPERATOR PRO
15