Assign Joystick To Pan & Tilt; Recording Moving Lights; Record A Moving Light Scene - Elation DMX OPERATOR PRO User Manual

7.2 Assign Joystick to Pan & Tilt (Cont.)
(10) Now that you've assigned your Pan and Tilt channels to the joystick, you need to
confirm and save these settings to memory. To do this, press the "RECORD" button
one (1) time. The LCD display will momentarily read "GOOD". You can now exit menu
mode by pressing the "ESC" button two (2) times. You now should have control of
the pan and tilt using the joystick for all assigned lights.

7.3 Recording Moving Lights

7.3.1 Record a Moving Light Scene

This next section will take you through the necessary steps to record moving light Scenes. You will
be using the section for moving lights which is located on the left side of your console or all
buttons to the left of the LCD display- including buttons in the LCD display section. The Scene
buttons you will be recording to- are located on the upper top left section of your console
numbered 1 through 8. Scenes can be played back one of two ways. The first way is to manually
trigger each desired scene and the second is to include the desired group of scenes into a Chase
for automatic sequential playback.
(1) Press and hold down the "RECORD" button for three (3) seconds or until the green
LED next to the RECORD button comes on. The LCD will display the following:
(2) If this is your first time recording Scenes, you should start saving them on Page #01-
please go to step #3 now. If you want to select a different page number from what is
displayed, press the "PAGE" button so that the red LED above the Page button
comes ON and then use the "UP" and "DOWN" buttons to scroll through to the other
pages. To select the new page, simply stop on the desired page and go to step #3.
There are a total of 12 pages.
SELECT A SCENE
OR CHASE! PAGE01
DMX OPERATOR PRO
12