Table of Contents
Advertisement
3. As each connection is made, the Link LED (on the AT-8324SX switch)
Wiring Closet
Today, the punch-down block is an integral part of many of the newer
Connections
equipment racks. It is actually part of the patch panel. Instructions for
making connections in the wiring closet with this type of equipment
follows.
1. Attach one end of a patch cable to an available port on the switch,
2. If not already in place, attach one end of a cable segment to the back
3. Label the cables to simplify future troubleshooting.
Make sure each twisted pair cable does not exceed 100 meters
(328 feet) in length.
corresponding to each port will be green to indicate that the
connection is valid.
and the other end to the patch panel.
of the patch panel where the punch-down block is located, and the
other end to a modular wall outlet.
AT-8324SX Switch
Patch Panel
Figure 17 Wiring Closet Connections
AT-8324SX Installation Guide
Equipment Rack (side view)
Punch-Down Block
Wall
47
Advertisement
Table of Contents
