Skipping Unused Inputs - Onkyo A-9070 Instruction Manual

Skipping Unused Inputs

You can hide the display of those inputs that are not used,
so that they are skipped when selecting an input. Change
any input from the following: L1(LINE1), L2(LINE2),
L3(LINE3), CX1(COAX1), CX2(COAX2), OPT,
PNO(PHONO)
■
Operating with the remote controller
SETUP
1
Press SETUP.
2
Press !/" repeatedly to select "SHOW".
3
Press ENTER.
4
Press !/" repeatedly to select the input you want
to change.
5
Press #/$ to switch between ON and OFF.
ON:
Shows the display of selected input.
OFF:
Hides the display of selected input.
The setting is automatically confirmed.
6
Press RETURN repeatedly to exit the setup.
En
36
■
Operating on the integrated amplifier
!/"/#/$
ENTER
RETURN
1
Press SETUP repeatedly to select "SHOW".
2
Use the INPUT selector to select the input you want
to change.
3
Press and hold down SETUP.
The setting is switched ON/OFF.
The setting is automatically confirmed.
4
Press SETUP repeatedly to exit the setup.
Tip
• The default setting is ON.
Note
• The current input doesn't appear as selectable. For example, if
the input is currently set to "LINE1", "L1" won't appear as
selectable.
• The integrated amplifier will end the setup if there is no
operation for 8 seconds.
INPUT selector
SETUP