Adc Errors (200 To 299) - HP 8560A Service Manual

124 NOP IBLK
125 NOP STRNG
126 NO ?
127 BAD DTMD
128 PK WHAT?
129 PRE TERM
130 BAD TDF
131 ?? AM/FM
132 !FAV/RMP
133 !INT/EXT
134 ??? ZERO
135 ??? CURR
136 ??? FULL
137 ??? LAST
138 !GRT/DSP
139 PLOTONLY
141 BAD ARG
142 BAD ARG
143 NO PRESL
Invalid COUPLING argument, expected AC or DC.
144 COUPL??

ADC Errors (200 to 299)

These errors are directly related to the ADC/Interface Section.
Suspect a faulty A2 Controller or A3 Interface assembly.
200 SYSTEM ADC Driver/ADC Hardware/firmware interaction; check for other
errors.
201 SYSTEM ADC Controller/ADC Hardware/firmware interaction; check for other
errors.
250 OUTOF RG ADC input is outside of ADC range.
Microprocessor not receiving interrupt from ADC.
251 NO IRQ
I-block format not valid here.
Strings are not valid for this command.
This command cannot be queried.
Not a valid peak detector mode.
Not a valid peak search parameter.
Premature A-block termination.
Arguments are only for TDF command.
AM/FM are not valid arguments for this command.
FAV/RAMP are not valid arguments for this command.
INT/EXT are not valid arguments for this command.
ZERO is not a valid argument for this command.
CURR is not a valid argument for this command.
FULL is not a valid argument for this command.
LAST is not a valid argument for this command.
GRT/DSP are not valid arguments for this command.
Argument can only be used with PLOT command.
PWRON is not a valid argument for this command.
Argument can only be used with FDIAG command.
Query expected for FDIAG command.
No preselector hardware to use command with.
General Troubleshooting 6-17