Miele H 370 Operating Instructions Manual page 72

Electrical connection UK, IRL, ZA
All electrical work should be under-
taken by a suitably qualified and
competent person in strict accord-
ance with national and local safety
regulations.
Installation, repairs and other work
by unqualified persons could be
dangerous. The manufacturer can-
not be held responsible for unauth-
orised work.
Ensure power is not supplied to the
appliance while installation or repair
work is being carried out.
The
are given on the data plate, visible
below the oven interior, with the oven
door open. Ensure that these match the
household mains supply. Please quote
these data, and the model and serial
number when contacting the Miele Ser-
vice dept.
Connection of this appliance should be
made either via a fused connection unit
(rated load under 3000 W), or via a suit-
able isolator (rated load over 3000 W),
which complies with national and local
safety regulations, and the on/off
switch should be easily accessible
after the appliance has been built in.
If the socket is not accessible after in-
stallation (depending on country) an ad-
ditional means of disconnection must
be provided for all poles.
For extra safety it is advisable to install
a residual current device with a trip cur-
rent of 30 mA (in accordance with DIN
VDE 0664, VDE 0100 Section 739).
When switched off there must be an all-
pole contact gap of 3 mm in the isola-
72
tor switch (including switch, fuses and
relays acc. to EN 60 335).
This appliance is supplied with a 3-
core cable for connection to a single
phase 230-240 V 50 Hz supply.
The wires are coloured in accordance
with the following code:
Green/yellow = earth
Blue = neutral
Brown = live
In other countries check these details
with your supplier.
This is not available in all countries.
For some countries the version of the
oven with integral hob controls is sup-
plied for connection to a 3N ~ 400 V
power supply.
Any adaptations must on be carried out
in consultation with the relevant Miele
Service Dept.
Possible combinations:
Miele built-in ovens may only be com-
bined with hobs and their respective
control units as specified by Miele for
use with that oven.
Contact your Miele Dealer for further in-
formation on suitable combinations.