Miele H 370 Operating Instructions Manual page 57

Remove the catalytic back panel
and roof panels before using oven
sprays. The chemicals used in oven
sprays will damage catalytic ena-
mel rendering it ineffective.
Apply a spray oven cleaner to the
soiled areas. Leave to take effect for
If necessary use a soft sponge (e.g.
the Vileda sponge as supplied with the
oven), soft nylon brush or a scraper
suitable for glass surfaces to loosen
the soiling.
Repeat the process if necessary.
After cleaning rinse thoroughly with
clean water and then dry thoroughly.
For optimum performance of the Per-
fectClean enamel it is important to
clean the oven and accessories after
each use.
The surfaces will become harder to
clean and the anti-stick properties will
deteriorate if soiling is not removed
after each use and allowed to build-up.
In extreme cases cleaning may even
become impossible.
The following cause lasting damage
to the surface structure and reduce
the anti-stick effect and must not be
used on PerfectClean surfaces:
– abrasive cleaning agents
– cleaning agents for ceramic hobs
– wire wool or metal scourers
– pot scourers
– oven cleaning pads
– sponges and cloths which have
previously been used with
abrasive cleaning agents.
– oven spray must not be used in a
hot oven or left on for too long.
– items coated with PerfectClean
enamelling must not be cleaned
in a dishwasher.
Soiling such as spilt juices and cake
mixtures are best removed whilst the
oven or tray is still warm. Exercise cau-
tion, make sure the oven is not hot -
danger of burning!
Spilt fruit juices may cause lasting dis-
colouration of the surfaces and roast-
ing can cause matt areas to appear.
Clean these following the instructions
given above and do not try and use
force to remove them! This discolour-
ation is permanent but will not affect
the efficiency of the enamel.
57