Electrical Connection - Miele H 215 B Operating Instructions Manual

Electrical connection

All electrical work should be under-
taken by a competent person in
strict accordance with national and
local safety regulations.
The
on the data plate, visible when the
oven door is open. Please ensure that
these match the household mains sup-
ply. Please quote these data, and the
model and serial number when contact-
ing the Miele Service dept.
Connection of this appliance should be
made either via a fused connection unit
(rated load under 3000 W), or via a suit-
able isolator (rated load over 3000 W),
which complies with national and local
regulations, and which is accessible
after the appliance has been built in.
The "B" model is supplied with a 3-core
cable for connection to a 230-240 volt
50 Hz supply, with 20 amp fusing.
The wires are coloured in accordance
with the following code:
Green/yellow = earth
Blue = neutral
Brown = live
In other countries check these details
with your supplier.
58
Q\}
This is not available in all countries.
For some countries the version of the
oven with integral hob controls is sup-
are given
plied for connection to a 3N ~ 400 V
power supply.
Any adaptations must only be carried
out in consultation with the relevant
Miele Service Dept.
The version of the built-in oven with
hob controls may only be combined
with one of the hobs listed below, and
the correct KSE electronic control for
that hob, (not all units are available in
every country):
KM 220
KM 221
KM 222
KM 230
KM 232
KM 240
KM 242
KM 243
KM 245
KM 246
KM 247
KM 248
KM 251
KSE 200
KSE 202-1
KSE 204-1