Configuring The Sources - Meridian G91 Installation Manual

Configuring the sources

If you are using the DVD player as the controller or video switcher
in your Meridian system, you can use the Source config option
on the Setup menu to configure each of the sources.
• Highlight Source config... in the Setup menu, and press
Enter.
The Source configuration menu will be displayed:
Option Values
Enabled Yes, No
Audio input (G91 only) A1-A3, D1-D2, O1-O2, Disc, Tuner
Sensitivity (G91 only) 2.5V, 2.0V, 1.0V, 0.5V
Video input V1-V2, S1-S3, Y1, Bypass, Disc
Video lock Normal, Poor
Trigger High, Low
Comms cat/add -C, 1C-9C, NC/1A-8A
To configure a source
• Press the source key on the remote corresponding to the source
you want to configure.
The Source configuration menu shows the values of each option
defined for that source.
To change an option
• Highlight the corresponding option in the Source
configuration menu and press Enter, select the value you want
to use, and press Enter to select it.
The following table explains the function of each of the options:
Description
Whether the source appears on the list of sources.
The audio input used for the source; analogue, digital, optical,
and internal.
Allows you to set the sensitivity of the analogue inputs.
Video input used for the source.
Improves locking for poor video sources
Trigger output for the source.
Allows you to set the Comms category and address.
4 1
C o n f i g u r i n g
t h e D V D p l a y e r