Table of Contents
Advertisement
Configuring the sources
If you are using the DVD player as the controller or video switcher
in your Meridian system, you can use the Source setup option on
the Setup menu to configure each of the sources.
• Highlight Source setup... in the Setup menu, and press Enter.
The Source setup menu will be displayed:
Option
Values
Enabled
Yes, No
Audio input
A1-A3, D1-D2, O1-O2, Disc, Tuner
Sensitivity
2.5V, 2.0V, 1.0V, 0.7V
Video input
V1-V2, S1-S3, Y1, Bypass, Disc
Video lock
Normal, Poor
Trigger
High, Low
HDMI switch
1 to 4
Comms cat/add
-C, 1C-9C, NC/1A-8A
To configure a source
• Press the source key on the remote corresponding to the source
you want to configure.
The Source configuration menu shows the values of each option
defined for that source.
To change an option
• Highlight the corresponding option in the Source
configuration menu and press Enter, select the value you want
to use, and press Enter to select it.
The following table explains the function of each of the options:
Description
Whether the source appears on the list of sources.
The audio input used for the source; analogue, digital, optical, and
internal; see below.
Allows you to set the sensitivity of the analogue inputs.
Video input used for the source.
Improves locking for poor video sources
Trigger output for the source.
Available if HDMI switch is set to On in the HDMI setup menu.
Allows the G92 to control the input on the HDMAX 421.
Allows you to set the Comms category and address.
C o n f i g u r i n g
t h e D V D p l a y e r
Advertisement
Table of Contents
