Meridian G91 Installation Manual page 44

4 0
C o n f i g u r i n g
t h e D V D p l a y e r
The options are summarised in the following table:
Option
Left/Right
Centre
Subwoofer
Surround
Analogue Out
Calibration...
To calibrate the speaker layout (G91 only)
• Highlight Calibration... in the Speakers menu, and press
Enter.
The Calibration menu will be displayed:
• Highlight Distance units and press Enter to change the
distance units between cm and inches.
Values
Small, Large
Off, Small, Large
Off, On
Off, Small, Large
None, Sub, Centre, Centre/Sub,
Left/Right, Surround
Description
Whether the main left and right loudspeakers should handle the bass (Large).
Whether there is a centre loudspeaker, and its bass handling.
Whether there is a subwoofer.
Whether there are rear surround speakers, and their bass handling.
Whether the analogue outputs are used to drive one or two analogue
speakers, and if so, their positions.
See below.
Then for each speaker adjust the Gain and Distance as follows:
• Press to highlight the Gain figure and press Enter to edit it.
You will hear a noise test signal from the corresponding channel.
• Press or to decrease or increase the gain in 0.5 dB steps,
and press Enter to confirm it.
Adjust the Gain values so all the speakers sound equally loud at
the listening position.
• Press to highlight the Distance figure and press Enter to
edit it.
• Measure the distance from the listening position to the speaker
and enter the value using the
keys, and press Enter to confirm it.
• Press Return when you have entered the values for all the
speakers.
or keys, or the MSR+ number