Working With System Alarms - Adaptec CDP-00278-02-A User Manual

The Set Properties window opens.
3. On the General Settings tab, in the NCQ drop-down list, select
4. Click Apply.

Working with System Alarms

Warning- or Error-level events on a system trigger an audible alarm, a series of beeps which sound every
five minutes (or 300 seconds) until the event is resolved.
The alarm is enabled by default, but can be disabled on any system, if required. You can also change
the frequency and duration of the alarm.
Note: A system alarm is not the same as a controller alarm. For controller alarm
information, see Working with Controllers
To change alarm settings on a system:
1. In the Enterprise View, select a system.
2. On the ribbon, in the System group, click System Settings.
The maxView Storage Manager Agent Settings window opens. The alarm settings are circled in the
next figure.
3. Edit the alarm settings, as needed.
You can disable the system alarm by deselecting Sound Alarm.
Proprietary and Confidential to PMC-Sierra, Inc.
Document No.: CDP-00278-02-A Rev. A, Issue:
maxView Storage Manager User's Guide
Enabled
on page 81.
or .
Disabled
83