Sending A Test Message - Adaptec CDP-00278-02-A User Manual

8. When you're done adding email recipients, click OK.
The email recipients and your SMTP server settings are saved.
9. Repeat the steps in this section for each system you want to monitor with email notifications, then
continue by sending test messages to all recipients (see

Sending a Test Message

To ensure that an email recipient is receiving event notifications, you can send them a test message.
To send a test message:
1. In the Enterprise View, select the system you want.
2. On the ribbon, in the System group, click System Settings.
3. When the System Settings window opens, click the Email tab.
The Email Notifications Manager opens.
4. Select one or more email addresses to send a test message to. To select all addresses, click the check
box at the top of the list, as shown in the figure below.
Proprietary and Confidential to PMC-Sierra, Inc.
Document No.: CDP-00278-02-A Rev. A, Issue:
maxView Storage Manager User's Guide
Sending a Test Message on page 96).
96