Table 2-3 Prestige Default Settings - ZyXEL Communications Prestige 623 series User Manual

Prestige 623 Series Dual-link ADSL Router
The Prestige Default Settings table below lists important default settings (others are described in the
subsequent chapters). Verify that they meet the needs of your network, or follow the instructions to change
them if necessary.
Before modifying any settings, review Chapter 3 for general information about using the web configurator.
You don't need to make changes to the default settings unless your ISP supplies you with additional
information.
OPTION
Web
Configurator
ATM Properties
DHCP (Dynamic
Host
Configuration
Protocol)
NAT (Network
Address
Translation)
LAN/USB Port
IP Address
2-10

Table 2-3 Prestige Default Settings

DEFAULT SETTING
Login user name: admin
Login password: 1234
One ATM interface
defined with these
properties:
Supports aal5
VPI = 8
VCI = 35
MUX type: LLC
DHCP server enabled with
a pool of addresses (for
LAN and USB ports):
192.168.1.3 through
192.168.1.34
(subnet mask =
255.255.255.0)
napt rule enabled
Assigned static IP
address: 192.168.1.1
subnet mask:
255.255.255.0
EXPLANATIONS/INSTRUCTIONS
The login user name and password allow you to login
and configure the embedded web configurator on your
Prestige.
The VPI and VCI values determine the path of your
connection to your ISP. You don't need to change the
default settings unless your ISP instructs you with
additional information. See chapter on ATM VCC for
additional instructions.
The Prestige maintains a pool of private IP addresses
for dynamic assignment to your LAN/USB computers.
To use this service, you must have set up your
computers to accept IP information dynamically, as
described in the Setting Up Your Computer's IP
Address appendix. See later chapter for an
explanation of the DHCP service.
Your computers' private IP addresses (see DHCP
above) will be translated to your public IP address
whenever they access the Internet. See chapter on
NAT service.
This is the IP address of the LAN port on the Prestige.
The LAN port connects the Prestige to your Ethernet
network. Typically, you will not need to change this
address. See section on changing the Prestige LAN IP
address.
Hardware Installation and Initial Setup