FIELD
Use DHCP
Default Route
Gateway Address
Status
Action
16.4 Adding EOA Interfaces
In the RFC 1483/ Ethernet over ATM (EoA) Config screen click Add to display the EOA Interface –
Add screen as shown next.
The following table describes the fields in this screen.
Configuring EOA Interfaces
Table 16-1 EOA
When this option is Enable in the Add screen, this setting instructs the device to
accept IP information assigned dynamically by your ISP's DHCP server. If the
interface will be used for bridging with your ISP and you will not be routing data
through it, select Disable for this option.
Indicates whether the Prestige should use the IP address assigned to this
interface, if any, as its default route for your LAN. This can be Enable or Disable.
See the chapter on IP Routes for an explanation of default routes.
This field displays the IP address of the gateway device.
A green or red dot will display to indicate that the interface is currently enabled or
disabled, respectively. You cannot manually enable or disable the interface; a
disabled interface may indicate a problem with the DSL connection.
Icons you can click on to edit (
Figure 16-2 EOA Interface: Add
Prestige 623 Series Dual-link ADSL Router
DESCRIPTION
) or delete (
) the associated EOA interface.
16-3