Figure 2-11 Menu 3 - Data Port Setup; Table 2-6 Menu 3 - Data Port Setup Description - ZyXEL Communications Prestige 724 User Manual

source, set the Clock Source field to Internal; if you select the WAN router as your clock source, set the
Clock Source field to External.
To configure data port settings for your WAN router, enter 3 from the main menu to display Menu 3 –
Data Port Setup, as shown next. If you are unsure of any of this information, please check with your WAN
router vendor.
FIELD
Press [SPACE BAR] to select user if your Prestige is acting as a client
Line Type
or network if it is acting as a server. Press [ENTER] after you have
made your selection.
Link This function is responsible for monitoring the up/down status and error
Management performance of an individual link. If failure occurs, it also initiates
recovery actions for the restoration of the failed link.
Press [SPACE BAR] to select ANSI (T1.617) or ITU-T (Q.933).
If your Prestige is a server, then select the mode that applies to your
region. If your Prestige is a client, select the mode that the server side
selects. The Prestige and its peer must use the same Link
Management mode.
Clock Source Press [SPACE BAR] to select Internal if your Prestige provides a clock
to its peer and External if the clock is provided by its peer. Press
[ENTER] after you have made your selection.
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.
Hardware Installation and Initial Setup
Menu 3 – Data Port Setup
Line Type= network
Link Management= ANSI (T1.617)
Clock Source= Internal
Press ENTER to Confirm or ESC to Cancel:
Figure 2-11 Menu 3 — Data Port Setup
Table 2-6 Menu 3 — Data Port Setup Description
DESCRIPTION
Prestige 724 G.SHDSL CSU/DSU
EXAMPLE
network
ANSI
(T1.617)
Internal
(default)
2-13