Turning On Your Prestige; Figure 2-3 Power-On Display - ZyXEL Communications Prestige 724 User Manual

Step 1. Connecting the xDSL Line
Connect the Prestige (port labeled xDSL) into the telephone jack using the telephone cable (supplied).
Step 2. Connecting the DATA Port to your Router
Connect one end of the included data port cable (V.35 or X.21) to the DATA port of your Prestige and the
other end to your router.
Step 3. Connecting a Computer to the Prestige
For the initial configuration of your Prestige, you need to use terminal emulator software on your computer
and connect it to the Prestige through the CONSOLE port. Connect the 9-pin end of the console cable to
the console port of the Prestige and the other end (choice of 9-pin or 25-pin, depending on your computer)
end to a serial port (COM1, COM2 or other COM port) of your computer. You can use an extension RS-
232 cable if the enclosed one is too short. After the initial setup, you can modify the configuration remotely
through telnet connections.
Step 4. Connecting the Power Adapter to your Prestige
Connect the power adapter to the port labeled POWER on the rear panel of your Prestige.
To prevent damage to the Prestige, first make sure you have the correct power
adapter. See the Power Adapter Specification Appendix for regional
2.4

Turning On Your Prestige

You can now turn on your Prestige by flipping the power switch to the on position (I is ON, O is OFF).
Step 1. Initial Screen
When you turn on your Prestige, it performs several internal tests as well as line initialization. After the
initialization, the Prestige prompts you to press [ENTER] to continue, as shown.
Copyright (c) 1994 - 2001 ZyXEL Communications Corp.
HWSAR (FPGA) : programming (11969) ... done
HWSAR (FPGA) : testing ... done
Wan Channel init ............ done
Press ENTER to continue...
Hardware Installation and Initial Setup
specifications.

Figure 2-3 Power-On Display

Prestige 724 G.SHDSL CSU/DSU
2-3