Table of Contents
Advertisement
8.1
Problems Starting the Prestige
PROBLEM
No LEDs are on
Make sure that the Prestige's power adapter is connected to the Prestige and plugged
when the
in to an appropriate power source.
Prestige is
Make sure the Ethernet device connected to the LAN port is on and working properly.
turned on.
Turn the Prestige off and on again.
If error persists, it may be a hardware problem. Contact technical support.
8.2
Power Problems
PROBLEM
The SYS LED
Prestige power is low and consequently may be disconnected from the ADSL line.
is red.
This is a "dying gasp" warning signal.
1.
2.
3.
Troubleshooting
This chapter covers potential problems and the corresponding remedies.
Table 8-1 Problems Starting the Prestige
Table 8-2 Problems With the Power Source
Make sure you are using the correct power adapter.
Make sure you have sufficient power for the operation of your Prestige. Make
sure you do not have too many electrical appliances connected to the same
power source.
Check the power connections between the Prestige and your power source.
Prestige 650M-17 ADSL Modem
Troubleshooting
CORRECTIVE ACTION
CORRECTIVE ACTION
Chapter 8
8-1
Advertisement
Table of Contents
