Table of Contents
Advertisement
Prestige 650M-17 ADSL Modem
FIELD
VPI #
VCI #
ATM QoS Type
Peak Cell Rate
(PCR)
Sustain Cell Rate
(SCR)= 0
Maximum Burst
Size (MBS)= 0
Filter Sets:
Input Device Filters
Output Device
Filters
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or [ESC]
to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
4.1.3 Outgoing Authentication Protocol
For obvious reasons, you should employ the strongest authentication protocol possible. However, some
vendors' implementation includes specific authentication protocol in the user profile. It will disconnect if
the negotiated protocol is different from that in the user profile, even when the negotiated protocol is
stronger than specified. If the peer disconnects right after a successful authentication, make sure that you
specify the correct authentication protocol when connecting to such an implementation.
4-4
Table 4-1 Remote Node Profile Menu Fields
Enter the Virtual Path Identifier (VPI) that the telephone company
gives you.
Enter the Virtual Channel Identifier (VCI) that the telephone
company gives you.
Press [SPACE BAR] and select CBR (Continuous Bit Rate) to
specify fixed (always-on) bandwidth. Select UBR (Unspecified Bit
Rate) for applications that are non-time sensitive, such as e-mail.
This is the maximum rate at which the sender can send cells. Type
the PCR.
Sustained Cell Rate is the mean cell rate of a bursty, on-off traffic
source that can be sent at the peak rate, and a parameter for burst-
type traffic. Type the SCR; it must be less than the PCR.
Refers to the maximum number of cells that can be sent at the
peak rate. Type the MBS. The MBS must be less than 65535.
Apply filters for incoming traffic. See Chapter 5 for information on
filters.
Apply filters for traffic leaving the Prestige. See Chapter 5 for
information on filters.
DESCRIPTION
EXAMPLE
UBR
Remote Node Configuration
0
32
0
0
0
Advertisement
Table of Contents
