Air Flow Adjustment; Timer Operation - Zibro S1523 Operating Manual

Air flow adjustment

During Cooling, Dry
During Circulating,
Operation
Dry Operation
level
Approx. 10
level
degrees
Approx. 60
degrees (70)
level
Approx. 10
degrees
Approx. 45
level
degrees
Approx. 10
degrees (40)
Approx. 45
degrees (70)
(5 kW / 6.4 kW Heat Pump models)
NOTE!
• When the operation is off, the vertical louver closes the outlet automatically.
• Do not move the vertical louver by hands. It may make the louver not to work correctly. In
order to move the vertical louver, use wireless remote controller without fail. In case the louver
does not work correctly, once stop the operation and turn on again.
• During in cooling or dry operation, the vertical louver should not be downward for long time.
If this is done, dew drops may appear at the outlet. (Even the louver direction is in the swing
range, the louver will move about 10 degrees from the horizontal after one hour.)
• During cooling operation, the angle of the vertical louver may automatically change to
prevent condensation.
Horizontal Adjustment
Adjust the horizontal louver by moving the adjustment tabs. If the system is ope-
rated with the horizontal louver faced completely to the left or right under high
humidity (e.g., during the rainy season), dew drops may appear at the outlet.

Timer operation

Before setting the timer, confirm that the present time is set accurately. Once you set the timer, the remote
controller memorizes the setting. From the next time, you can operate the same timer mode just by pres-
sing the ON/OFF button and the Timer fixing ("ON/OFF Timer") button.
You can use the combined function of the "ON Timer" and "OFF Timer".
"ON Timer"
Example: set the "ON Timer" to 7 a.m.
Operation starts at the set time.
Vertical adjustment
The vertical louver will move automatically to the suitable position when
ON/OFF button is pressed.
Swing of air flow
The vertical louver will keep moving within the range illustrated on the
left, if the vertical louver button is pressed once.
Fixing the air flow Direction
If the louver button switch is pressed again, the vertical louver will be
fixed and that position is memorized. From the next operation the lou-
ver will be set at previous position automatically.
4
13