Automatic Operation - Zibro S1523 Operating Manual

Automatic operation

In automatic operation the air conditioner selects the operation mode (cooling, dry, heating) according to
the room temperature when it starts.
How to select operating mode
Heating Dry Cooling
Auto Recovery Function
lf there is any power failure during operation, operation status before power failure is memorized. 3~4
minutes after power recover, the unit restarts automatically with previous operation status memorized. (3~4
minutes is protective time for compressor.)
ATTENTION
Because of Auto Recovery Function, if shutting off the power supply during operation, the unit
may restart irrespective your intention when turning on the power supply next time. If the unit is
not to be used for a long time, shut off the power supply after terminating all operation with
remote controller.
1.
2.
3.
4.
5.
NOTE
• If the selected mode by Automatic Operation does not suit you, set the operation mode
(cooling, dry heating) with the Operation mode button.
• Even if you press the ON button after the stop, the air conditioner will not start operation for
approx. 3 min. in order to protect the compressor. The operation will start automatically after 3
min. of waiting.
4
12
• The air conditioner will restart in the previous mode if auto-
matic operation is resumed within 3 hours from the switch-
off.
Room temperature
• Mode review
The computer checks and compares the room temperature 5
minutes and 15 minutes apart after the compressor shuts
off, and it will review the mode. Afterwards it is repeated
every 10 minutes.
Press the ON/OFF button
Set the operation mode to Automatic
button.
Adjust the setting temperature by pressing the temperature setting button.
Temperature setting range:16~30°C by 1°C step.
Adjust the fan speed by pressing the fan speed button. When the mode is set
at "AUTO" the fan speed changes automatically.
Press the ON/OFF button again. The system will retain the previous setting
conditions until next operation.
, by pressing the operation mode