Table of Contents
Advertisement
Paramagnetic O2 Purity Analyzer
To setup an Auto–Cal cycle:
Choose System from the Function buttons. The VFD will
display five subfunctions.
Use < > arrows to blink
screen for Span/Zero set appears.
Press < > arrows to blink
again. (You won't be able to set OFF to ON if a zero interval is
entered.) A Span Every ... (or Zero Every ...) screen appears.
Use
arrows to set an interval value, then use < > arrows to
move to the start-time value. Use
value.
To turn ON the Span and/or Zero cycles (to activate Auto-Cal): Press
System again, choose
Span/Zero screen appears, use the < > arrows to blink the
/
field. Use
O F F
O N
now turn these fields
4.3.3 Password Protection
If a password is assigned, then setting the following system parameters
can be done only after the password is entered: span and zero settings,
alarm setpoints, analysis range definitions, switching between
autoranging and manual override, setting up an auto-cal, and assigning a
new password. However, the instrument can still be used for analysis or
for initiating a self-test without entering the password.
If you have decided not to employ password security, use the default
password
This password will be displayed automatically by the
T E T A I .
microprocessor. The operator just presses the Enter key to be allowed total
access to the instrument's features.
NOTE: If you use password security, it is advisable to keep a copy of the
password in a separate, safe location.
Teledyne Analytical Instruments
C o n t r a s t A u t o — C a l
P S W D L o g o u t M o r e
A u t o — C a l
S p a n O F F N x t :
Z e r o O F F N x t :
Span
S p a n E v e r y 0
S t a r t 0 h f r o m n o w
and press Enter again. When the
,
A u t o — C a l
arrows to set the
O F F
because there is a nonzero span interval defined.
O N
Operation
, and press Enter. A new
0 d 0 h
0 d 0 h
), then press Enter
(or
Zero
d
arrows to set a start-time
(or
S p a n
/
field to
. You can
O N
O N
)
Z e r o
45
Advertisement
Table of Contents
