Password Protection; Entering The Password - Teledyne 3010TAC Operating Instructions Manual

4 Operation
Press < > arrows to blink
won't be able to set OFF to ON if a zero interval is entered.) A Span
Every ... (or Zero Every ...) screen appears.
Use arrows to set an interval value, then use < > arrows to move to
the start-time value. Use
To turn ON the Span and/or Zero cycles (to activate Auto-Cal): Press
System again, choose
Zero values screen appears, use the < > arrows to blink the Span (or Zero)
/
field. Use
now turn these fields

4.3.3 Password Protection

If a password is assigned, then setting the following system parameters
can be done only after the password is entered: span and zero settings,
alarm setpoints, analysis range definitions, switching between autoranging
and manual override, setting up an auto-cal, and assigning a new password.
However, the instrument can still be used for analysis or for initiating a self-
test without entering the password.
If you have decided not to employ password security, use the default
password TETAI. This password will be displayed automatically by the
microprocessor. The operator just presses the Enter key to be allowed total
access to the instrument's features.
NOTE: If you use password security, it is advisable to keep a copy of
the password in a separate, safe location.
4.3.3.1
To install a new password or change a previously installed password,
you must key in and ENTER the old password first. If the default password
is in effect, pressing the ENTER button will enter the default TETAI pass-
word for you.
Press System to enter the System mode.
4-6: Part I
Span OFF Nxt: 0d 0h
Zero OFF Nxt: 0d 0h
), then press Enter again. (You
Span (or Zero
Span Every 0 d
Start 0 h from now
arrows to set a start-time value.
and press Enter again. When the Span/
Auto—Cal,
arrows to set the
because there is a nonzero span interval defined.

Entering the Password

Teledyne Analytical Instruments
/
field to . You can
Model 3010TAC