Fiery EX2101 Job Management Manual page 123

6
6-5 Imposition settings
Creep Adjustment
Choose either Plain or Thick from the Creep Adjustment menu, or enter a value
(between 0 and 2 inches, or the equivalent in another measurement unit) to specify the
thickness of the sheet. When saddle-stitched binding is specified, DocBuilder Pro uses
this value to compensate automatically for binder's creep (see "Shingling and creep" on
page A-8).
Even if you choose Thick from the Creep Adjustment menu, your job prints on
N :
OTE
Plain paper, unless you specified Thick paper in the job properties. For more
information on changing job properties from Command WorkStation, see "Viewing
and overriding print settings" on page 3-14.
Orientation
Use the Orientation menu to specify the orientation of a sheet. As an alternative to
rotating the sheet, you can perform custom rotations on any page in the main window,
as described in "Rotating pages" on page 6-22.
Duplex
Use the Duplex menu to specify the relationship of content areas on opposing sides of
a sheet. Specify On for duplex (two-sided) printing or Off for simplex (one-sided)
printing.
When you choose On, the job is printed as duplex using a Top-Top setting, meaning
that the tops of pages on opposing sides of a sheet are located on the same edge (usually
the preferred choice for imposed book layouts).