Xblue Networks PCS digital User Manual page 24

Base Unit
To remove power from the Base Unit by unplugging port 1
Place Dip Switch 1, in the up position, turning if off, while leaving switches 2 and 3 in
the down position, turning them on. See below:
Note: The LED will flash in the "Registration Mode" Cadence (125 milliseconds on, 125 milliseconds off).
Dipswitch 1 is off (up) and Dipswitches 2 and 3 are on (Down), which takes about five (5) seconds.
Plug port 1 in – restoring power to the base unit
Wait 5 seconds – the LED begins flashing rapidly. For the next 30 seconds, while the
LED is rapidly flashing, PRESS THE "OK" (F3) BUTTON on the Handset.
If successful, the handset will update:
Note: If Handset 2 is being register the display will say "HANDSET #2"
The display shows that the handset is now on line:
If the registration process is unsuccessful the following will be seen:
Before proceeding remember to place the dipswitches in the "Normal" position (All
switches up, in the off position) as seen below.
Wireless Key Telephone Handset
1 2 3
ON
(( ))
REGISTRATING
PLEASE WAIT...
(( ))
> REGISTERED
HANDSET # 1
(( ))
JAN01 TUE 4:14
NAME 12
(( ))
FAILED!
TRY AGAIN!
1 2 3
ON
- 24 -