Verizon MI424-WR User Manual page 76

5
Using Network Connections
5.5 Coax Connection
General
The top part of the screen displays general communication parameters. We
recommend not changing the default values in this section unless familiar with
networking concepts.
Status Displays the status of the coax connection.
When should this rule occur? Displays when the rule is active. To schedule
rules, see the "Advanced Settings" chapter.
Network Select the type of connection being configured from the drop-down
list (options: Network [Home/Office], Broadband Connection, or DMZ).
Connection Type Displays the type of connection.
Physical Address Displays the physical address of the network card used for
the network.
MTU MTU (Maximum Transmission Unit) specifies the largest packet size
permitted for Internet transmission. "Automatic" sets the MTU at 1500. Other
choices include "Automatic by DHCP, " which sets the MTU according to the DHCP
connection, and "Manual, " which allows the MTU to be set manually.
Coax Link
Set up the coax link options in this section of the Configure Coax screen.
Options include Channel, Privacy, and Password.
Channel Select the Channel from the drop-down list (select from 1-6,
or "Automatic").
Privacy Toggle "Privacy" by clicking in the "Enabled" check box. If Privacy is
activated, all devices connected via coaxial cable must use the same password.
We recommend leaving the Privacy option deactivated.
Password Enter the Coax Link password in this text box.
CM Ratio Select the CM Ratio from the drop-down menu here.
© 2010 Verizon. All Rights Reserved.
76