Verizon MI424-WR User Manual page 24

2
Connecting the FiOS Router
2.3 Configuring the FiOS Router
3. Make sure the corresponding Ethernet LAN light on the front of the FiOS
Router glows steadily green.
4.
Repeat these steps for each computer to be connected to the FiOS Router
via Ethernet.
Wireless
1.
Make sure each computer to be connected wirelessly has built-in wireless or
an attached wireless adapter.
2. Make sure the computer uses the same ESSID and WEP key as the FiOS
Router by launching the computer's wireless application
3.
Enter the ESSID and WEP key found on the sticker on the bottom of the
FiOS Router in the computer's wireless settings and click Save. Make sure to
configure the computer to use 64/40-bit WEP encryption.
4. Make sure the changes were implemented by surfing the Internet from
the computer.
5.
Repeat these steps for every other computer to be connected to the
FiOS Router wirelessly.
Coaxial
1.
Make sure all set top boxes are turned off.
2. Disconnect any adapter currently connected to the coaxial jack in the room
where the FiOS Router is.
3.
Connect one end of the coaxial cable to the coaxial wall jack, and the other
end to the red Coax port on the back of the FiOS Router.
4.
Power up the set top box.
5. Make sure the Coax LAN light on the front of the FiOS Router glows steadily
green. This may take a few minutes. When it does, the set top box is
connected to the FiOS Router.
© 2010 Verizon. All Rights Reserved.
24