Setting The Repeat Recording And Partition Of Main; Device <Main Hdd Setting; Setting The Repeat Recording - Mitsubishi DX-TL308E Installation Manual

Registering the devices (continued)
Setting the repeat recording and
partition of Main device
Notice
• You cannot make settings during access to the HDD
such as recording and playback. In addition, you
cannot start recording or playback during setting.

Setting the repeat recording

You can set the recorder's operation performed when the
available space in Main device runs out during recording.
1 Press the SET UP button on the front panel of
Step
the recorder or left-click the mouse.
<Main menu> is displayed.
•
2 Select [HDD registration].
Step
HDD registration
<HDD registration> screen is displayed.
•
3 Select [Setting] next to [Main HDD setting].
Step
Setting
<Main device setting> screen is displayed.
•
4 Select whether to enable or not the repeat
Step
recording in each area.
To enable the repeat recording, put a checkmark in
•
the box.
[Enable]: Automatically returns to the start of the
HDD and resumes recording (overwriting).
[Disable]: Stops recording at the end of the HDD.
When [Warning] of [Remain] on the <Warning
display • Buzzer • Call-out 1> screen (
is selected, recording resumes as the warning is
cleared.
When [Warning] of [Remain] on the <Warning
display • Buzzer • Call-out 1> screen (
is unselected, recording resumes as the recorded
data are deleted or the repeat recording is enabled.
38
<Main HDD setting>
or
page 99)
page 99)
Notice
• The repeat recording in the partitioned areas can be
enabled only when the corresponding areas are set in
the <Partition setting>.
• When a warning is issued, "Please push the help
button" is displayed on the screen. The recorder keeps
the latest 16 warnings. The warnings issued before
them are reset and not displayed.
• When the repeat recording is disabled in the alarm
recording area or emergency recording area and
their available space runs out, the alarm recording
or emergency recording stops. When an alarm or
emergency signal is input after that, the indicator
i l l u m i n a t e s f o r a m o m e n t b u t r e c o r d i n g i s n o t
performed. (You may not notice that the indicator
illuminates.) In this case, enable the repeat recording
or delete the recorded data to resume recording.