Multiplexer Settings; Output A/Output B; Copy Output A Settings; 4-Split And 9-Split - Mitsubishi DX-TL308E Installation Manual

Various settings (continued)

Multiplexer settings

You can confi gure the multiplexer settings for Output A and
Output B individually.

Output A/Output B

You can set the camera numbers displayed on the split
screen on the monitor connected to OUTPUT A or OUTPUT
B. (The settings of Output A are applied to OUTPUT A,
and those of Output B to OUTPUT B.) You can also make
sequential display settings. Sequential display is a function
to automatically switch the displayed images from the
selected cameras at constant intervals.
1 Select [Setting] next to the output you want to
Step
set (Output A or Output B).
The screen for setting the selected output is
•
displayed.

Copy Output A settings

You can copy the settings of Output A to Output B.
1 Select [Execute] next to [Copy Output A settings].
Step
When a confi rmation screen is displayed, select [Yes].
•

4-split and 9-split

Notice
• 9-split screen is available for DX-TL308E only.
<DX-TL308E>
4-split screen 9-split screen
Set the camera numbers to be displayed on each split screen.
You can select different cameras for Output A and Output B.
1 Select [Setting] next to the split screen mode you
Step
want to change.
The screen for setting the selected split screen mode
•
is displayed.
2 Left-click repeatedly on the number until the
Step
desired camera number appears
<DX-TL308E> Numbers from 1 to 8 and [- -] are
•
displayed.
<DX-TL304E> Numbers from 1 to 4 and [- -] are
displayed.
Notice
• You cannot set more than one same camera number
within the same split screen mode.
• When you select [- -], the camera number is displayed
as [--] on the normal screen.
104
<Multiplexer setting>
Step
Step
Step
When an alarm signal is input, the screen according to the
<DX-TL304E>
pre-designated selection is displayed. When another alarm
4-split screen
signal is input during alarm recording, the images from the
cameras recorded upon input of the latest alarm signal are
displayed on the specified screen. After the completion
of the alarm recording, the screen returns to the original
display mode.
Step
Step

Sequential display

Example
When you make single
sequence settings as follows:
Camera numbers 1 to 4
Display interval: 2 seconds
The screen display automatically switches.
1 Select [Setting] next to [Sequential display].
The screen for setting the sequential display is
•
displayed.
2 To set the display order in the single-screen
sequential display mode, set [Single sequential
display].
<DX-TL308E> When you click on the number, it
•
changes from 1 to 8 and [- -] in order.
<DX-TL304E> When you click on the number, it
changes from 1 to 4 and [- -] in order.
3 To set the display switching interval in the
sequential display mode, designate the desired
interval in [Display interval].

Alarm display

Example
During
normal recording
A trigger for alarm recording
selected by the recording setting is input.
Displayed on the
4-split screen
1 Select the output for activating the alarm display
function.
[Off]: Alarm display function is disabled.
2 Select the screen display mode to be used when
an alarm signal is input for each of the connected
sensors.
Setup menu
2 seconds
later
2
1
2 seconds 2 seconds
later later
4 3
2 seconds
later
During
alarm recording
The screen automatically
switches according to the
pre-determined selection.