Connections; Connecting Cctv Cameras, Monitors, And Sensors - Mitsubishi DX-TL308E Installation Manual

Connections

Camera
<DX-TL308E> (up to 8 cameras)
<DX-TL304E> (up to 4 cameras)
RS232C
integral camera
RS422
integral camera
To CAMERA IN
connectors
corresponding to the
camera numbers
XGA (PC) monitor (DX-TL308E only)
For setting, see
Power cord
for the Continent
for U.K
<Cable termination>
Cable end connected to ALARM IN
or I/O terminal and RS422
5-7 mm strip-off
Applicable wire
0.32-0.65 mm
(AWG 28-22)
24

Connecting CCTV cameras, monitors, and sensors

Secure the USB cord using the
supplied clamp band to prevent
disconnection. (
Secure the power cord using the
supplied clamp band to prevent
disconnection. (
For setting, see
pages 53 and 54.
To ALARM IN terminals
To GND
corresponding to the
terminal
sensor numbers
To XGA
port
page 105.
For setting, see
page 108.
PTZ control terminals
For setting, see
page 110.
RS422
integral camera
Page 26)
Page 26)
To SERIAL
BUS port
External recording device
DX-ZD6UE
Up to 4 devices can be used at the
same time. (The number of devices differs
depending on the operation manner.)
For setting, see page 36.
RS232C
integral camera
Monitor
To VIDEO IN
connector
To OUTPUT A
VIDEO connector
To VIDEO IN
connector
To OUTPUT B
connector
Monitor
* This illustration
shows an example
of DX-TL308E.
To LAN port
Mouse
For setting, see
pages 108 and 109.