Using The Setup Wizard; Making The Minimum Required Settings Automatically; Setup Wizard - Mitsubishi DX-TL308E Installation Manual

Using the Setup Wizard

Making the minimum required settings
automatically
When you turn on the power of the recorder for the first
time, the Setup Wizard screen is displayed for making the
minimum required settings.
Tips
• The Setup Wizard screen is automatically displayed
only when you first turn on the power. It is not
displayed from the next turn-on.
Turn on the power for the first time.
Select whether or not to use the Setup Wizard.
Language selection
HDD configuration
Step 1 Camera check
Step 2 Define the normal recording cycle
Step 3 Confirm the recording settings
1 After connecting cameras and monitors, turn
Step
on the MAIN switch on the rear of the recorder.
Check that the POWER indicator goes out and
then press the POWER button on the front panel
of the recorder.
The <Setup Wizard> screen is displayed.
•
Notice
• While the POWER indicator is blinking, the POWER
button does not work. When you turn on the MAIN
switch of the rear panel of the recorder, wait for more
than 5 seconds after the indicator goes out before
pressing the POWER button.
2 Select whether or not to use the Setup Wizard.
Step
Select [Next] when using the Setup Wizard and [Quit]
•
when not. When you select [Quit], the clock starts
from the initial setting.
32
<Setup Wizard>
1
Step
2
Step
3
Step
4
Step
Time/date adjust
5
Step
6
Recording setup Step
7
Step
8
Step
9
Step
10
Finish Step
Tips
• When you want to cancel the Setup Wizard in
midstream, cancel it according to the instructions
displayed on the screen. You can cancel the Setup
Wizard in step 6. In this case, the settings you made in
steps 1 to 5 remain effective.
3 (When you select [Next])
Step
Select a language.
The <Language selection> screen is displayed.
•
Select a language used for the menus.
Select a language and then [Next].
•
4 Set the current time and select [Set].
Step
-1
4 Select [Setting] and set the time zone depending
Step
-2
on the location of the recorder, and then select
[Set].
After fi nishing the setting, select [Return] to return to
•
the screen of step 4-1 and then [Next].
Tips
• When you select [Set], the clock starts.
5 Set the HDD confi guration.
Step
When you select [Register], all the connected HDDs
•
are automatically registered as Main device.
When the registration fi nishes, a confi rmation screen
is displayed. Check the settings and select [Next].
For setting Copy device and Archive device, see
•
pages 34 to 37.
For mirroring setting, see
•
For partition setting, see
•
6 Select whether or not to make recording settings.
Step
Select [Next] when you make recording settings and
•
[Quit] when not.
7 (When you select [Next])
Step
W h e n y o u s e l e c t [ E x e c u t e ] , t h e r e c o r d e r
automatically detects the active cameras and
displays their numbers.
When the recorder fi nishes detecting the cameras,
•
select [Next].
The detection results are applied to Recording A-D,
•
emergency recording, and single sequential display.
8 Set the recording cycle and recording hours per
Step
day.
After fi nishing the setting, select [Next].
•
page 35.
page 39.