A&D SC-30KAM Instruction Manual page 18

Entering the upper and lower limit values
1. Press the
weighing unit, "kg", "lb" or "oz"
2. Press and hold the UNITS switch to
enter the upper limit setting mode.
3. Enter the upper limit value using the
following switches.
UNITS
PRINT
The minus sign can be selected as a
blinking digit after the least significant
digit.
The PRINT switch alternates the
minus sign on and off. The blinking "
shows minus and no sign is plus.
4. After setting all of the digits, press the
TARE switch. Then, the upper limit
value is stored and the display goes to
the lower limit setting mode.
5. Set the lower limit value in the same way
as the upper limit value setting procedure,
and press the TARE switch to return to
the weighing mode.
UNITS switch to select a
To shift the blinking digit
to the right.
To increase the value of
the blinking digit by one.
Press and hold
Press
-
"
16
Press
Press
Press
Set the lower limit
value