Table of Contents
Advertisement
x
/c
set verify=advanced|basic|1..5
x
/c
set verify=basic [pref=ddd:hh]
www.3ware.com
This command only applies to 9650SE and the 9690SA RAID controllers
running 9.5.1 or later.
This command is effectively the same as the set verify command. Setting
verify to advanced enables the advanced Verify Task Schedule, which can
include a series of up to 7 days and times. Setting verify to basic creates a
weekly schedule with one specific day and time, and disables the series of
scheduling slots associated with the advanced Verify Task Schedule. For more
about the basic schedule, see "/cx set verify=basic [pref=ddd:hh]", below.
The priority of verify versus I/O operations is specified with 1..5, where 1 is
more resources and 5 the least. Setting this value to 1 implies fastest verify,
and 5 implies fastest I/O.
For information on the verify schedule, see "/cx add verify=ddd:hh:duration"
on page 63
This command only applies to 9650SE and the 9690SA RAID controllers
running 9.5.1 or later.
Using the verify=basic option allows you to set a basic verify schedule that
starts each week at the same date and time. With verify=basic, you can
specify your preferred day and time, or you can omit the day and time and use
the default of Friday at midnight.
When you set verify=basic, the series of scheduled days and times associated
with the advanced Verify Task Schedule is ignored.
Verify=basic is intended to be used with the auto-verify policy for RAID
units, to insure that a verification of the unit occurs on a regular basis.
Note:
When verify=basic, if you start a manual verify, it will start immediately.
When verify=advanced, if you start a manual verify, it will follow the advanced
Verify Task Schedule. For more information, see "/cx/ux start verify" on page 83.
Example:
//localhost> /c3 set verify=basic pref=Fri:23
Setting /c3 basic verify preferred start time to [Fri, 11:00PM]
... Done.
Controller Object Commands
68
Advertisement
Table of Contents
