Siemens optiPoint 500 economy User Manual page 78

Using Other Functions/Services
Step by Step
78
If this function has been configured (consult service
personnel), you can set up external outgoing calls from
outside the system, just like an internal user. You can
also activate and deactivate the following functions in
your system:
• Reset services, code: #0
• Call forwarding, code: *11/#11
• Forwarding - trunk, code: *64/#64
• Call forwarding - no answer, code: *14/#14
page 26
• Changeover on/Changeover off
code: *66/#66
• Change PIN, code: *93
• Open door, code: *61
• Do not disturb, code: *97/#97
• Speed-dial, code: *7
• Room monitor,
• Night answer, code: *44/#44
• Control Relay, code: *90/#90
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
o
Set up a connection to HiPath 1200. Enter the station
number (DISA-MSN, consult service personnel) and
wait for the continuous tone (if necessary, switch the te-
lephone to tone dialing).
o
Enter your internal station number.
o
Enter your personal PIN and wait for the dial tone.
o
Enter the code, such as,
Make other inputs as necessary; (refer to the operating
instructions for pulse and DTMF telephones).
or
o
Dial the external number.
You can only execute one function at a time, or
set up only one outgoing connection.
The connection is immediately released after
successful activation of a function.
In the case of an external-external call, the con-
nection is released as soon as either of the par-
ties ends the call.
page 77
page 24
page 70
page 72
page 35
page 68
page 39
page 69
page 53
page 80
97 for Do not disturb on.
*
page 25