Installing The Short Document Adapter; Adjusting The Height Of The Scanner (I5800 Scanner Only) - Kodak i5000 series User Manual

Installing the short
document adapter
Adjusting the height of the
scanner (i5800 Scanner
only)
3-6
The short document adapter can be used when scanning small documents
(i.e., checks). This adapter aids in better document stacking.
1. Open the document stop on the output tray as shown in the illustration.
2. Slide the short document adapter over the document stop and push it all
the way down.
3. Adjust the sides guides if necessary.
The workspace table can be raised approximately 25.4 cm (10 in.) from its
lowest position for your comfort when you are sitting or standing at the
scanner. When you are raising or lowering the workspace table, be sure that
there is nothing close to the scanner that would interfere with the upward and
downward movement (e.g., chair, table, etc.).
• Press the upper portion of the button on the side of the scanner to raise to
workspace table.
• Press the lower portion of the button on the side of the scanner to lower the
workspace table.
If the workspace table will not move up or down from its position, check the
following:
• Be sure the workspace table is not already in its highest or lowest position.
• Be sure the scanner is on and is not in Low Power mode.
A-61670 February 2013